8 Tips for Overcoming Car Strikes After Crashing Floods

The rainy season has arrived, a number of paths that you take often have to be flooded by rain and even flood. Of course this makes it difficult and confused many car drivers. Besides being able to hinder the journey and even endanger the car driver, flooding also makes the driver worried when the car hits the flood.

So, what are the tips and tricks for crashing a flood using a car? Here are some safe driving tips when facing the rainy season.

Pay attention to the water level

When the road in your house is flooded and high enough, try to pay attention to the water level. The higher the puddle, the greater the risk of damaging the car. In essence, the flood that you want to go through is not close to or even higher than the air inlet of your vehicle. It would be nice if you were patient first and watch the car crash into another flood. Be patient first and pay attention to other cars when the car hits the flood whether your car is safe to follow it or not.

Determine the route and path, choose the lowest puddle and free from obstacles such as speed bumps, damaged roads or others. Because the key is when the car hits a flood when facing the rainy season, the constant speed of the car plays an important role in minimizing the risk of the car breaking down.

Keep your distance when the car hits the flood

As explained in the first point. Speed ​​is important, make sure the car in front has enough distance. It’s true, actually when we follow the car in front, we have the opportunity not to be submerged in the flood because the car in front splits the water. However, what will you do when the front car crashes into the flood.

So it’s best when the car hits the flood, keep a safe distance. Wait for the front car to have enough distance so that when the front car breaks down you have time to overtake it.

Follow the water waves when the car hits the flood

While crossing the flood, the front of the car hit the water and created a wave. This wave will move forward in the same direction and at a certain speed and leave a shallower water gap behind it. You don’t have to go ahead of the water wave, it’s the right thing to follow it from behind. Keep the momentum of the car so that the speed of the car with the wave is the same when the car hits the flood. That way you seem to be crossing a shallower flood.

Try low engine speed when the car hits the flood

Don’t believe the myth that says when you hit a flood, the engine speed must be high so that the engine doesn’t die easily or to fight the water that enters through the exhaust. Precisely when the car hits a flood and then we use a high rpm it will increase the suction power of air from the engine and the greater the water entering the engine room. This can result in water hammer symptoms and the car engine will break down.

Don’t press the clutch when the car hits the flood

For cars with manual transmissions, as much as possible release the clutch when passing through the flood. Keep the clutch plates tightly against each other and drive the car constantly when the car hits a flood. Too often using half the clutch or holding the car clutch will only increase the possibility of the clutch burning and increasing engine speed.

For cars with automatic transmission, point the transmission lever to position L or 1. During the car crashing into a flood, do not move the transmission so that the car’s speed can be maintained and the engine speed remains intact. The goal is that the rest of the exhaust gas coming out of the exhaust can hold back the rate of water entering the engine room through the exhaust line.

Turn off the engine immediately when in an emergency

If you miscalculated and the car is caught in a deep flood, don’t panic! Immediately turn off your friend’s car engine immediately to prevent water hammer conditions that can make the engine break. Likewise, when you feel there are signs that the engine has entered water and is about to die. By turning off the engine early, you will eliminate the risk of a water hammer when the car hits a flood.

Dry the brakes after the car hit the flood

After the car hit the flood, the brake disc will be wet and the resistance will be reduced due to the slippery surface. Dry the brakes by stepping on the brake pedal slightly accompanied by the gas pedal at the same time. Do this for about 20 seconds and then check the braking power by braking normally. If you feel the brakes are not working optimally, step on the pedal together for another 20 seconds, repeat these steps until braking returns to normal.

Checking the fluid after the car hit the flood

Arriving at home or a safe place, immediately check the fluid in the engine and transmission. Floods that touch the bottom of the engine and gearbox can make water seep in and mix with the lubricant. If the color of the oil turns light or cloudy like milk, it means it has been contaminated with water. Immediately replace the contaminated fluid.